This Selecting Vinyl Details the different types of vinyl flooring and what works best in different parts of the home. -721 Be sure to check your motor for the correct mounting hole locations. Then drill the holes in the plywood mounting base slightly over-size to aid in positioning the motor. In the case of the motor we used, the bolt holes are 1/4, so we drilled the holes 3/8 to give a bit of slop so the bolts go into the base a bit easier. Provide at least 3 of space between the rear of the alternator and the battery. This will provide ample space for access to the alternator terminals. Next, use some scrap chunks of 2 by 4s positioned with the 2 side down, to build a 4 tall box around the battery. We cut them to length, and then secured them to the base from underneath using 2 wood screws. Its much easier if the holes are drilled before trying to install the screws. What we did was to cut the first 2x4, then positioned it on the far side of the battery. We marked the outer location with a pencil. Then we moved the battery, and marked the inside of the 2x4. We did the same thing for the other 3 scraps. Once the outlines of the 2x4s were marked, we pre drilled the holes in the base. Next, we positioned the 2x4s one at a time back on the base, and drilled into the bottom of the 2x4s from the opposite side of the base, using the holes in the base as a drill guide. Then we installed the screws through the base and into the 2x4 scraps. Once complete, the battery fits right in the box! "national home energy rating scheme " and "magnetic motor italy " (include "are magnets used in electric motors", "magnetic gravity motor ", "battic door home energy monitor ", "panasonic home energy storage ", "how many people use wind energy ", "How to make photovoltaic cells ", 21 Nov 2009 Suntech Power aims to boost its share of the U.S. market with a solar-panel manufacturing plant to be built in Arizona & How to build a simple windmill )